Cisco Systems 1300 Series manual Changing the Access Point/Bridge Output Power

Appendix D Channels and Antenna Settings

Maximum Power Levels and Antenna Gains

Table D-2	Maximum Power Levels Per Antenna Gain for IEEE 802.11g (continued)
			Maximum Power Level (mW)
Regulatory Domain		Antenna Gain (dBi)	CCK	OFDM
Japan (-J)		5.2 (Omni)	10	10
(10 mW/MHz EIRP maximum)
		9 (Patch)	10	10
		10 (Yagi)	10	10
		11 (Omni)	10	10
		12 (Omni)	10	10
		13 (Integrated patch)	10	10
		13.5 (Yagi)	10	10
		14 (Sector)	10	10
		21 (Dish)	10	10

1. A minimum of 2 dBi cable loss must be be used for this configuration.

Changing the Access Point/Bridge Output Power

This section provides instructions for changing the access point/bridge output power to comply with the maximum power limits imposed by regulatory domains (see “Maximum Power Levels and Antenna Gains” section on page D-3). Follow these instructions to change the output power settings using your browser:

Note Administrator privileges may be required in order to change access point/bridge settings.

Note To meet regulatory restrictions, the external antenna access point/bridge unit and the external antenna must be professionally installed. The network administration or other IT professional responsible for installing and configuring the unit is a suitable professional installer. Following installation, access to the unit should be password protected by the network administrator to maintain regulatory compliance.

Step 1 Open your Internet browser.

Step 2 Enter the access point/bridge IP address in the browser address or location line and press Enter. An Enter Network Password screen appears.

Step 3 Enter your username (default Cisco) in the User Name field.

Step 4 Enter the access point/bridge password (default Cisco) in the Password field and press Enter. The Summary Status page appears.

Step 5 Click Network Interfaces and the network interface menu appears.

Step 6 Click Radio0-802.11Gand the 802.11G Status screen appears.

Step 7 Click the Settings tab and the settings screen appears.

Step 8 On the CCK Transmit Power (mW) setting, select the maximum CCK power allowed for your antenna in your regulatory region.

Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide

D-4 OL-5048-02