Cisco Systems 1300 Series manual Safety Information, Outdoor and Vehicle Installations

Chapter 2 Installation Overview

Safety Information

Warning Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can come into contact with such circuits. When installing the antenna, take extreme care not to come into contact with such circuits, as they may cause serious injury or death. For proper installation and grounding of the antenna, please refer to national and local codes (e.g. U.S.:NFPA 70, National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).

Statement 1052

Outdoor and Vehicle Installations

The following warning applies to outdoor and vehicle installations:

Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030

Vehicle Bridge Installations

The following warnings apply to vehicle bridge installations:

Warning A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement 1022

Warning Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV) requirements in IEC 60950 based safety standards. Statement 1033

Safety Information

Follow the guidelines in this section to ensure proper operation and safe use of the access point/bridge.

FCC Safety Compliance Statement

The FCC, with its action in ET Docket 96-8, has adopted a safety standard for human exposure to RF electromagnetic energy emitted by FCC-certified equipment. When used with approved Cisco Aironet antennas, Cisco Aironet products meet the uncontrolled environmental limits found in OET-65 and ANSI C95.1, 1991. Proper operation of this radio device according to the instructions in this publication results in user exposure substantially below the FCC recommended limits.

Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide

OL-5048-02 2-3