Cisco Systems 1300 Series Access Point/Bridge Bracket, Mast Bracket, Mast Type, Mast Diameter

Chapter 3 Mounting and Alignment Overview

Mounting Hardware

Figure 3-1 Multi-Function Mount

2

1

117119

1

Access point/bridge bracket with support pins

2

Mast bracket

Access Point/Bridge Bracket

The access point/bridge bracket mounts on the back side of the unit housing. The bracket mounts on four lugs on the unit. The bracket contains two support pins that are used to suspend the unit in the notches on the mast mounting bracket until you secure the mounting bolts.

The access point/bridge must be positioned to obtain the correct antenna polarization that matches the remote antenna. The integrated access point/bridge antenna is vertically polarized. All access point/bridges must use the same antenna polarization for best operation.

Mast Bracket

The mast bracket attaches to a mast or tower support and is used to secure the access point/bridge (see Table 3-1).

Table 3-1	Mast Bracket Attachment Methods
Mast Type		Mast Diameter	Mast Attachment Method
Roof mount,		1.5 to 2.75 in.	Attach the pipe inside the mounting bracket,
small mast, or tower		(30.5 to 69.9 mm)	between the bracket and access point/bridge.

Note The U-bolts provided with the roof mounting kit support mast diameters up to 1.75 in. (44.5 mm). For larger masts, you must supply the U-bolts to attach the access point/bridge.

Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide

3-4 OL-5048-02