Cisco Systems 1300 Series manual Access Point/Bridge Specifications, A P P E N D I X C

A P P E N D I X C

Access Point/Bridge Specifications

This appendix provides technical specifications for the access point/bridge, power injector, and power module. Table C-1lists the technical specifications.

Table C-1		Access Point/Bridge, Power Injector, and Power Module Specifications
	Category		Access Point/Bridge	Power Injector and Power Module
	Size		Integrated antenna configuration:	Power injector:
			8.00 in. W x 8.10 in. H 2.62 in. D	4.62 in. W x 4.76 in. H x 1.07 in. D
			(20.32 cm W x 20.57 cm H 6.66 cm D)	(11.74 cm W x 12.09 cm H x 2.72 cm D)
				Power module:
				3.88 in. L x 1.24 in. W x 2.17 in. D
				(98.5 mm L x 31.4 mm W x 55.0 mm D)
	LEDs		Four LEDs on the back panel: Radio traffic,	One bi-color power LED on the side panel
			Ethernet traffic, status, and Installation and
			Alignment Mode
	Connectors		Bottom panel (left to right): Power injector	Side panel (left to right): Two coaxial uplink
			dual-coax ports (two F-type connectors) and two	F-type connectors, 48-VDC power connector,
			reverse-TNC antenna connectors	RJ-45 connector for 100BASE-T Ethernet,
				and a RJ-45 serial console port connector
	Operating Temperature		–22 to 131oF (–30 to 55oC)	Power injector:
				–22 to 131oF (–30 to 55oC)
				Power module:
				32 to 104oF (0 to 40oC)
	Non-Operational		–40 to 185oF (–40 to 85oC)	Power injector:
	Temperature			–40 to 185oF (–40 to 85oC))
				Power module:
				–40 to 185oF (–40 to 85oC)
				(10,000 ft. limit)
	Humidity		0 to 90% (condensing)	Power injector:
				0 to 90% (non-condensing)
				Power module:
				0 to 95% (non-condensing)
			Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
	OL-5048-02				C-1