Cisco Systems 1300 Series manual LEDs

Chapter 3 Mounting and Alignment Overview

LEDs

LEDs

The LEDs indicate the startup status, operating mode, association status, and received signal strength. This information simplifies the process of activating the link and positioning the antenna from the access point/bridge mounting location. The LEDs are mounted on the back of the housing (see Figure 3-2).

Figure 3-2 LEDs

R S E

I

117061

RRadio LED

SStatus LED

EEthernet LED

IInstall LED

When the access point/bridge running Cisco IOS 12.3(4)JA is initially powered-up, the unit defaults to a root access point with the radio disabled and no default SSID. To allow client associations, you must configure an SSID and enable the radio interface (refer to the “Configuring the Access Point/Bridge for the First Time” section on page 5-1).

When the access point/bridge running Cisco IOS 12.3(2)JA2 and earlier is initially powered-up, the bridge installation mode is activated and the unit attempts to associate to a root bridge for 60 seconds. If it is unable to associate with a root bridge, it automatically assumes the root bridge role.

Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide

OL-5048-02 3-5