Cisco Systems 1300 Series manual Category, Access Point/Bridge, Power Injector and Power Module

Appendix C Access Point/Bridge Specifications

Table C-1	Access Point/Bridge, Power Injector, and Power Module Specifications (continued)
Category		Access Point/Bridge	Power Injector and Power Module
Operational Vibration		SAE J1455	Power injector:
			SAE J1455
Non-Operational		SAE J1455	Power injector:
Vibration			SAE J1455
Environmental Testing		The enclosure has been successfully tested and is in	—
Compliance		compliance with a NEMA 4 enclosure rating.
Weight		2.5 lbs (1.13 kg)	Power injector—0.8 lbs (0.36 kg)
			Power module—1.0 lbs (0.5 kg)
Input Voltage		48 VDC (nominal)	Power injector (nominal):
		53 VDC (maximum)	48 VDC (LR2 power injector)
			12 to 40 VDC (LR2T power injector)
			Power module:
			100 to 240 VAC
Power Consumption		13W (typical)	—
Radio Output Power		100, 50, 30, 20, 5, or 1 mW	Power injector:
		(at 1, 2, 5.5, and 11 Mbps)	18W (maximum at 48 VDC) supplied to
		30, 20, 10, 5, or 1 mW	the access point/bridge through dual-coax
		(at 6, 9, 12, 18, 24, 48, and 54 Mbps)	cables
		(Depending on the regulatory domain in which the	Power module:
		access point/bridge is installed)	18W (maximum at 48 VDC)
Frequency		2.400 to 2.497 GHz	—
		(Depending on the regulatory domain in which the
		access point/bridge is installed)
Modulation		IEEE 802.11b-compliant radio:	—
		Direct Sequence Spread Spectrum (DSSS)
		Complementary Code Keying (CCK)
		IEEE 802.11g-compliant radio:
		Orthogonal Frequency Division Multiplex
		(OFDM)
Subcarrier modulation		CCK (5.5 Mbps and 11 Mbps)	—
		BPSK (1 Mbps, 6 Mbps and 9 Mbps)
		QPSK (2 Mbps, 12 Mbps and 18 Mbps)
		16-QAM (24 Mbps and 36 Mbps)
		64-QAM (48 Mbps and 54 Mbps)

Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide

C-2 OL-5048-02