17-13
Cisco ONS 15600 Procedure Guide, R8.0
Chapter17 DLPs E100 to E199
DLP- E113 Provision a Half Circuit Source and Destination on a Path Protection
DLP-E113 Provision a Half Circuit Source and Destination on a Path ProtectionStep 1 From the Node drop-down list, choose the node that will contain the half circuit.
Step 2 From the Slot drop-down list, choose the slot containing the card where the circuit will originate.
Step 3 From the Port drop-down list, choose the port where the circuit will originate.
Step 4 If applicable, choose the source STS.
Step 5 If you want to create a path protection with two sources, click Use Secondary Source and repeat Steps
1 through 4. If not, skip this step and continue with Step 6.
Step 6 Click Next.
Step 7 From the Node drop-down list, choose the node chosen in Step1.
Step 8 From the Slot drop-down list, choose the destination slot.
Step 9 From the Port drop-down list, choose the destination port.
Step 10 If applicable, choose the destination STS.
Step 11 If you want to create a path protection with two destinations, click Use Secondary Destination and
repeat Steps 7 through 10.
Step 12 Return to your originating procedure (NTP).
Purpose This task provisions a half circuit source and destination for a path
protection. This task is used to create path protection selectors on the node.
Depending on the specific network configuration, the path protection
selector can be created on the source side (two sources, one destination);
the destination side (one source, two destinations); or both (two sources,
two destinations). Selectors are required on both the source and destination
sides when two STS path protection paths (rings) are interconnected at a
single node.
Tools/Equipment None
Prerequisite Procedures NTP-E83 Create a Half Circuit on a Path Protection Node, page 6-20
The Source page of the Circuit Creation wizard must be open.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher