17-17
Cisco ONS 15600 Procedure Guide, R8.0
Chapter17 DLPs E100 to E199
DLP- E116 Remap the K3 Byte
Step 8 Return to your originating procedure (NTP).
DLP-E116 Remap the K3 Byte
Caution If you remap the K3 byte, remap to the same extended byte (Z2, E2, or F1) on either side of the span.
Step 1 In node view, double-click the card that connects to the third-party equipment.
Step 2 Click the Provisioning > Line tabs.
Step 3 Click BLSR Ext Byte and choose the alternate byte: Z2, E2, or F1.
Step 4 Click Apply.
Step 5 Repeat Steps 1 through 4 at the node and card on the other end of the BLSR span.
Note The extension byte set in Step 3 should match at both ends of the span.
Step 6 Return to your originating procedure (NTP).
DLP-E119 Set Auto-Refresh Interval for Displayed PM Counts
Step 1 In node view, double-click an OC-N card. The card view appears.
Step 2 Click the Performance tab.
Purpose This task provisions the K3 byte. Do not remap the K3 byte unless
specifically required to run an ONS 15600 BLSR through third-party
equipment. This task is unnecessary for most users.
Tools/Equipment None
Prerequisite Procedures DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher
Purpose This task changes the window auto-refresh intervals for updating the PM
counts.
Tools/Equipment None
Prerequisite Procedures DLP-E26 Lo g into CTC, page 16-33.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher