17-47
Cisco ONS 15600 Procedure Guide, R8.0
Chapter17 DLPs E100 to E199
DLP- E157 Disable Alarm Filtering
DLP-E157 Disable Alarm FilteringStep 1 In the node, network, or card view, click the Alarms tab.
Step 2 Click the Filter tool at the lower-right side of the bottom toolbar.
Alarm filtering is enabled if the tool is selected and disabled if the tool is raised (not selected).
Step 3 If you want alarm filtering disabled when you view conditions, click the Conditions tab and repeat
Step 2.
Step 4 If you want alarm filtering disabled when you view alarm history, click the History tab and repeat
Step 2.
Step 5 Return to your originating procedure (NTP).
DLP-E158 Manually Lock or Unlock a User on a Single NodeStep 1 In node view, click the Provisioning > Security > Users tabs.
Step 2 Choose the user you want to lock out.
Step 3 Click Change.
Step 4 Complete one of the following:
•To lock a user out so the user cannot log into the node, check the Locked out check box.
•If the user is currently locked out, uncheck the Locked out check box.
See the “DLP-E130 Change Security Policy on a Single Node” task on page 17-26 for more
information about manual lockouts and lockout duration.
Step 5 Click OK. A confirmation dialog box appears.
Purpose This task turns off specialized alarm filtering in all network nodes so that
all severities are reported in CTC.
Tools/Equipment None
Prerequisite Procedures DLP-E155 Enable Alarm Filtering, page 17-44
DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
Purpose This task manually locks out or unlocks a user from a single node.
Tools/Equipment None
Prerequisite Procedures DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser