Teledyne 9060Z Number of oxygen probes, Oxygen range, Oxygen accuracy, Thermocouple types, Power

Model 9060Z Manual

Caution, risk of danger. See additional information in the manual.

3.1HARDWARE SPECIFICATIONS

3.1.1TRANSMITTER SPECIFICATIONS

	2 maximum
Number of oxygen probes:
	0‐1% to 0‐100%
Oxygen range:
	±1% of actual measured oxygen value with a repeatability of ±0.5% of
Oxygen accuracy:
	the measured value
	Type K, J, R and S
Thermocouple types:
	±2°C
Temperature accuracy:
	0‐20mA or 4‐20mA field selectable
Analogue outputs:
	Active outputs (Do NOT loop power these outputs)
	1000 ohm max
Output load:
	4
Alarm relays:
	2A/240VAC, 2A/30VDC
Alarm relay contacts:

(WARNING: Do not use both mains voltage and low voltage connections to adjacent alarm contacts)

	100 to 240VAC, ‐6 +10%, 50/60 Hz
Mains voltage supply:
	Category II (IEC60364‐4‐443)
Overvoltage:
	5W for controller plus probe power
Power:
	530W max., 25% duty cycle each probe on 240VAC
	110W max., 100% duty cycle each probe on 110VAC
	2.5A max
	3A, fast blow, 250v, 20x5mm (heater fuses, 2 of)
Fuses:
	1A, slow blow, 250v, microfuse (PCB mtg fuse, 1 of)
	Operating Temperature ‐25°C to 55°C
Environmental Rating:
	Relative Humidity 5% to 95% (non‐condensing)
	2000m maximum
Altitude
	IP65
Degree of Protection:
	IP54 with internal reference air pump
	260mm (10.2”) wide, 160mm (6.3”) high, 90mm (3.5”) deep
Case Size:
	3 Kg (6.6 lbs.)
Weight:

WARNING: All signal level connections onto the transmitter must be treated as safety extra‐low voltage (SELV) as defined in the standard IEC61140. Double insulation must be used when connecting these terminals to systems that might carry high voltage.

3.1.2 STANDARD ‘U’ LENGTHS

9060H	9060UL/UH
250 mm (10”)	500 mm (20”)
350 mm (14”)	750 mm (30”)
500 mm (20”)	1000 mm (40”)
750 mm (30”)	1500 mm (60”)
1000 mm (40”)

1500 mm (60”)

2000 mm (80”) Ordering Information

10