Model 9060Z Manual
TABLE OF CONTENTS |
|
TABLE OF CONTENTS | 1 |
1. IMPORTANT NOTICES | 7 |
2. INTRODUCTION | 8 |
2.1 9060Z TRANSMITTER | 8 |
2.2 SERIES 9060H OXYGEN PROBES & SENSORS | 8 |
2.3 WARNING SYMBOLS | 9 |
3. DEVICE SPECIFICATIONS | 10 |
3.1 HARDWARE SPECIFICATIONS | 10 |
3.1.1 Transmitter Specifications | 10 |
3.1.2 Standard ‘U’ Lengths | 10 |
3.1.3 Series 9060H Probes Specifications | 11 |
3.1.4 Oxygen Probe Model Selection Guide | 12 |
3.2 OPERATIONAL SPECIFICATIONS | 14 |
4. INSTALLATION AND COMMISSIONING | 15 |
4.1 MOUNTING THE TRANSMITTER | 15 |
4.2 INSTALLING A 9060H OXYGEN PROBE | 15 |
4.3 INSTALLING THE AUXILIARY THERMOCOUPLE | 17 |
4.4A SHIELD CONNECTIONS | 17 |
4.4B EARTH CONNECTION (PE) | 17 |
4.5 ELECTRICAL CONNECTIONS. ......................................................................................... 17 | |
4.6 HEATER INTERLOCK RELAYS | 20 |
4.7 CONNECTING AN OXYGEN PROBE CABLE | 20 |
4.8 CONNECTING THE AUXILIARY THERMOCOUPLE (OPTIONAL) | 22 |
4.9 CONNECTING THE OUTPUT CHANNELS | 22 |
4.10 CONNECTING THE ALARMS | 22 |
4.11 CONNECTING THE AUTOMATIC PURGE AND CALIBRATION CHECK SYSTEM | 22 |
4.12 CONNECTING REFERENCE AIR | 23 |
4.13 CONNECTING THE TRANSMITTER TO A MODBUS™ NETWORK | 23 |
4.14 CONNECTING POWER | 24 |
4.15 COMMISSIONING ‐ RUN MODE | 24 |
4.16 PROBE OR SENSOR CALIBRATION | 24 |
4.17 FILTER PURGING | 25 |
4.18 CALIBRATION GAS CHECK | 25 |
4.19 DUST IN THE FLUE GAS | 25 |
4.20 STRATIFICATION | 26 |
4.21 CONNECTING A PRESSURE TRANSDUCER | 26 |
5. DISPLAY AND KEYPAD | 27 |
5.1 GRAPHICAL DISPLAY | 27 |
5.2 OXYGEN DISPLAY UNITS | 28 |
2
