Model 9060Z Manual

9. ALARMS

The 9060Z has 4 alarm relays and a built in alarm annunciator. If an alarm occurs, the ALARM light will flash. To find out what the alarm is, press the ALARM up key.

When the ALARM up key has been pressed, the transmitter goes into the alarm display mode. In this mode some of the keys take on a special function.

Key text

 

RUN mode

ALARM mode

SETUP / RUN

 

*

Return to RUN mode

DISPLAY / FUNCTION up

*

Next alarm

DISPLAY / FUNCTION down

*

Last alarm

ALARM / OPTION up

Enter ALARM display mode

Alarm activated time

ALARM / OPTION down

Enter ALARM log mode

Alarm acknowledged time

ALARM ACCEPT / ENTER

*

Acknowledge alarm

GAS 1 PURGE 1

/ SENS IMP

*

*

GAS 2 PURGE 2

/ AUTO CAL

*

*

* This key is not used in the ALARM mode

The common alarm relay is used to monitor faults within the transmitter and the probe. The other three alarm relays relate to the process gas. All relays have user defined actions.

If one of the alarm events is removed from the common alarm using COMMISSIONING menu function #49, then this alarm event can be programmed for one of the other 3 alarm relays.

When the alarm mode has been entered, the SETUP light flashes once a second until the SETUP key is pressed to return the transmitter to RUN mode.

All relays have fail‐safe alarm contacts. That is –

When the transmitter is turned off the contacts are open circuit

When the transmitter is on but there are no alarms the contacts will be closed When there is a current unaccepted alarm event the contacts will be open circuit

When there is a current accepted alarm event the state of the contacts will depend on the selection in the commissioning menu #50. See chapter 7.2.22, Operation of the alarm relay when an alarm is accepted.

All alarms drive the alarm light on the front door. The light will be off if there are no alarms current

The light will flash if there is a current alarm that has not been acknowledged The light will be on steady if there are current alarm(s) that have not been cleared The light will flash faster as more alarms occur

9.1 COMMON ALARMS

The events that drive the common alarm are –

1.‘Probe 1 Heater Fail’

2.‘Probe 2 Heater Fail’

A heated probe (model 9060H) has been turned on for more than 20 minutes but is still not up to 650°C (1200°F) or the probe temperature falls below 650°C.

3. ‘Probe 1 High Impedance’

45

Page 45
Image 45
Teledyne 9060Z manual Common Alarms