17-16
Cisco ONS 15600 Procedure Guide, R8.0
Chapter17 DLPs E100 to E199
DLP- E115 Change the Service State for a Port
DLP-E115 Change the Service State for a Port
Step 1 In node view, double-click the card with the port(s) you want to put in or out of service. The card view
appears.
Step 2 Click the Provisioning > Line tabs.
Step 3 In the Admin State column for the target port, choose one of the following from the drop-down list:
•IS—Puts the port in the In-Service and Normal (IS-NR) service state.
•OOS, DSBLD—Puts the port in the Out-of-Service and Management, Disabled (OOS-MA,DSBLD)
service state. In this service state, traffic is not passed on the port until the service state is changed
to IS-NR; Out-of-Service and Management, Maintenance (OOS-MA,MT); or Out-of-Service and
Autonomous, Automatic In-Service (OOS-AU,AINS).
•OOS, MT—Puts the port in the OOS-MA,MT service state. This service state does not interrupt
traffic flow and loopbacks are allowed, but alarm reporting is suppressed. Raised fault conditions,
whether or not their alarms are reported, can be retrieved on the CTC Conditions tab or by using the
TL1 RTRV-COND command. Use the OOS-MA,MT service state for testing or to suppress alarms
temporarily. Change to the IS-NR or OOS-AU,AINS service states when testing is complete.
•IS, AINS—Puts the port in the OOS-AU,AINS service state. In this service state, alarm reporting is
suppressed, but traffic is carried and loopbacks are allowed. After the soak period passes, the port
changes to IS-NR. Raised fault conditions, whether their alarms are reported or not, can be retrieved
on the CTC Conditions tab or by using the TL1 RTRV-COND command.
Note CTC will not allow you to change a port service state from IS-NR to OOS-MA,DSBLD. You
must first change a port to the OOS-MA,MT service state before putting it in the
OOS-MA,DSBLD service state.
For more information about service states, refer to the “Administrative and Service States” appendix of
the Cisco ONS 15600 Reference Manual.
Step 4 If the port is in loopback (OOS-MA,LPBK & MT) and you set the Admin State to IS, a confirmation
window appears indicating that the loopback will be released and that the action could be service
affecting. To continue, click Yes.
Step 5 If you set the Admin State to IS,AINS, set the soak period time in the AINS Soak field. This is the
amount of time that the port will stay in the OOS-AU,AINS service state after a signal is continuously
received. When the soak period elapses, the port changes to the IS-NR service state.
Step 6 Click Apply.
Step 7 As needed, repeat this task for each port.
Purpose This task puts a port in service or removes a port from service.
Tools/Equipment None
Prerequisite Procedures DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher