17-14
Cisco ONS 15600 Procedure Guide, R8.0
Chapter17 DLPs E100 to E199
DLP- E114 Provision Section DCC Terminations
DLP-E114 Provision Section DCC Terminations
Step 1 In node view, click the Provisioning > Comm Channels > SDCC tabs.
Step 2 In the SDCC Terminations area, click Create.
Step 3 In the Create SDCC Terminations dialog box, click the ports where you want to create the DCC
termination. To select more than one port, press the Shift key or the Ctrl key.
Note SDCC refers to the Section DCC, which is used for ONS 15600 DCC terminations. You can
provision the SONET Line DCCs and SDCCs (when not used as a DCC termination by the
ONS 15600) as DCC tunnels. See the “DLP-E105 Create a DCC Tunnel” task on page 17-5. You
can provision SDCC and Line DCC on the same port but it is not recommend. SDCC and Line
DCC are only needed on the same port during a software upgrade if the software version does
not support SDCC. Provision Line DCC termination on the port that already has SDCC see
“DLP-E189 Provision Line DCC Terminations” task on page17-70. Delete SDCC provisioned
on that port, see “DLP-E198 Delete a Section DCC Termination” task on page17-76. Enable
OSPF on the Line DCC termination if not enabled see “DLP-E197 Change a Line DCC
Termination” task on page17-75.
Step 4 In the Port Admin State area, click Set to IS to put the port in service.
Step 5 Verify that the Disable OSPF on SDCC Link is unchecked.
Step 6 If the SDCC termination is to include a non-ONS node, check the Far End is Foreign check box. This
automatically sets the far-end node IP address to 0.0.0.0, which means that any address can be specified
by the far end. To change the default to a specific the IP address, see the “DLP-E196 Change a Section
DCC Termination” task on page17-75.
Step 7 In the Layer 3 box, perform one of the following:
•Check the IP box only—if the SDCC is between the ONS 15600 and another ONS node and only
ONS nodes reside on the network. The SDCC will use PPP (point-to-point protocol).
•Check the IP and OSI boxes—if the SDCC is between the ONS 15600 and another ONS node and
third party NEs that use the Open System Interconnection (OSI) protocol stack are on the same
network. The SDCC will use PPP.
•Check OSI box only—if the SDCC is between an ONS node and a third party NE that uses the OSI
protocol stack. The SDCC will use the LAP-D protocol.
Note If OSI is checked and IP is not checked (LAP-D), no network connections will appear in
network view.
Purpose This task creates SONET Section DCC terminations required for alarms,
administration data, signal control information, and messages.
Tools/Equipment None
Prerequisite Procedures DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher