17-25
Cisco ONS 15600 Procedure Guide, R8.0
Chapter17 DLPs E100 to E199
DLP- E128 Change the Node Name, Date, Time, and Contact Information
DLP-E128 Change the Node Name, Date, Time, and Contact Information
Note Changing the date, time, or time zone might invalidate node performance monitoring counters.
Step 1 In node view, click the Provisioning > General tabs.
Step 2 Change any of the following:
•General: Node Name
•General: Contact
•Location: Latitude
•Location: Longitude
•Location: Description
Note To see changes to longitude or latitude on the network map, you must go to network view
and right-click the specified node, then click Reset Node Position.
•Time: Use SNTP Server
•Time: Date (M/D/Y)
•Time: Time (H:M:S)
•Time: Time Zone
•Time: Use Daylight Saving Time
See the “NTP-E22 Set Up Date, Time, and Contact Information” procedure on page 4-4 for detailed field
descriptions.
Step 3 Click Apply. Confirm that the changes appear; if not, repeat the task.
Step 4 Return to your originating procedure (NTP).
Purpose This task changes basic node information such as node name, date, time,
and contact information.
Tools/Equipment None
Prerequisite Procedures DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher