Cisco Systems 1900 Series manual Chassis Ground Connection on the Cisco 1941 Router

Chapter 4 Installing and Connecting the Router

Installing the Chassis Ground Connection

To install the ground connection for a Cisco 1900 series router, follow these steps.

Procedure

Step 1 Strip one end of the ground wire to expose approximately 0.75 in. (20 mm) of conductor.

Step 2 Crimp the 14 AWG green ground wire to a UL Listed/CSA certified ring terminal that is suitably sized for the number 6 ground screw provided on the rear panel of the router. The crimping tool should be one that is recommended by the ring lug terminal manufacturer.

Step 3 Attach the ring terminal to the chassis. The attachment points are shown in Figure 4-10and Figure 4-11. Use a number 2 Phillips screwdriver and the screw supplied with the ground lug. Tighten the screw to a torque of 8 to 10 in-lb. (0.9 to 1.1 N-m).

Figure 4-10 Chassis Ground Connection on the Cisco 1905 and Cisco 1921 Routers

AUX	S
		GE 0/1
			L
CONSOLE	S	GE
		0/0	L

			Cisco
	POE			1905
BAUD
RESET
48VDC		1.67A
		100-
		240 V~
			50-60	Hz 1A

253714

Figure 4-11 Chassis Ground Connection on the Cisco 1941 Router

S

G E 0 / 0

EN

EN

CONSOLE

GE 0/1

L

251359

	Cisco 1900 Series Hardware Installation
4-10	OL-19084-02