Cisco Systems 1900 Series General Site Requirements

2-3

Cisco 1900 Series Hardware Installation

OL-19084-02

Chapter 2 Preparing for Router Installation

General Site Requirements

• If an electrical accident occurs, proceed as follows:

–

Use caution; do not become a victim yourself.

–

Turn off power to the device.

–

If possible, send another person to get medical aid. Otherwise, assess the victim’s condition and

then call for help.

–

Determine whether the person needs rescue breathing or external cardiac compressions; then

take appropriate action.

In addition, use the following guidelines when working with any equipment that is disconnected from a

power source, but is still connected to telephone wiring or other network cabling:

• Never install telephone wiring during a lightning storm.

• Never install telephone jacks in wet locations unless the jack is specifically designed for it.

• Never touch uninsulated telephone wires or terminals unless the telephone line is disconnected at

the network interface.

• Use caution when installing or modifying telephone lines.

Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry. ESD can occur if

electronic printed circuit cards are improperly handled and can cause complete or intermittent failures.

Always follow ESD prevention procedures when removing and replacing modules:

• Ensure that the router chassis is electrically connected to earth ground.

• Wear an ESD-preventive wrist strap, ensuring that it makes good skin contact. Connect the clip to

an unpainted surface of the chassis frame to channel unwanted ESD voltages safely to ground. To

guard against ESD damage and shocks, the wrist strap and cord must operate effectively.

• If no wrist strap is available, ground yourself by touching a metal part of the chassis.

Caution For the safety of your equipment, periodically check the resistance value of the antistatic strap. It should

be between 1 and 10 megohms (Mohm).

General Site Requirements

This section describes the requirements that your site must meet for safe installation and operation of

your router. Ensure that the site is properly prepared before beginning installation. If you are

experiencing shutdowns or unusually high errors with your existing equipment, this section can also help

you isolate the cause of failures and prevent future problems.

• Power Supply Considerations, page 2-4

• Site Environment, page 2-4

• Site Configuration, page 2-4

• Wireless LAN Considerations, page 2-5