Cisco Systems 2950 Assigning a Profile to a Specific LRE Port, Assigning a Global Sequence to All LRE Ports

13-13
Catalyst2950 and Catalyst2955 Switch Software Configuration Guide
78-11380-10
Chapter13 Configuring LRE Configuring LRE Ports
Assigning a Profile to a Specific LRE Port
You can set profiles on a per-port basis. You can assign the same profile or different profiles to the LRE
ports on the switch. The default active profile on all LRE ports is LRE-10 on the Catalyst 2950S T-8 LRE
and 2950ST-24 LRE switches and LRE-6 on the Catalyst 2950ST-24 LRE 997 switch.
The switch resets the ports with the updated profile settings when they are changed.
Beginning in privileged EXEC mode, follow these steps to assign a profile to a specific LRE port:
To delete the profile from a sequence, use the no profile profile-name interface configuration command.
To display the LRE link statistics and profile information on the LRE ports, use the show controllers
lre privileged EXEC command.
Assigning a Global Sequence to All LRE Ports
Global sequences are set on a switch-wide basis. If you assign a gl obal seque nc e to t h e sw itch, it
overrides any previously or subsequently set profiles. For more information on sequence and profile
precendence, see the “Guidelines for Using LRE Profiles” sec tio n on p ag e 13-10.
Changes to the global sequence settings are immediately put in effect, and the global mode automatically
becomes the active mode.
Beginning in privileged EXEC mode, follow these steps to assign a global sequence to the LRE por ts:
To delete the assigned sequence, use the no lre rate selection sequence sequence-name global
configuration command.
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 interface interface-id Specify the LRE port to be configured, and enter interface configuration
mode.
Step3 profile profile-name Enter the port profile name (select from the list in Table13-1 on page 13-3
or Table13-2 on page 13-4).
Step4 end Return to privileged EXEC mode.
Step5 show controllers lre profile details Verify the change.
Step6 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 lre rate selection sequence sequence-name Enter the global sequence name. Select from the list in Table13-3 on
page 13-5 and Table 1 3-4 on p ag e 13-6.
Step3 end Return to privileged EXEC mode.
Step4 show controllers lre status sequence Verify the change.
Step5 copy running-config startup-config (Optional) Save your entries in the configuration file.