1-14
Catalyst2950 and Catalyst2955 Switch Software Configuration Guide
78-11380-10
Chapter1 Overview
Network Configuration Examples
Servers are connected to the GBIC module ports on the switches, allowing 1-Gbps throughput to users
when needed. When the switch and server ports are configured for full-duplex operation, the links
provide 2 Gbps of bandwidth. For networks that do not require Gigabit performan ce f ro m a ser ver,
connect the server to a Fast Ethernet or Fast EtherChannel switch port.
Connecting a router to a Fast Ethernet switch port provides multiple, simult aneous ac cess to the Inte rnet
through one line.
Collapsed Backbone and Switch Cluster Configuration
Figure 1-3 shows a configuration for a network of approximately 500 employees. This network u ses a
collapsed backbone and switch clusters. A collapsed backbone has high-bandwidt h uplinks fr om all
segments and subnetworks to a single device, such as a Gigabit switch, that serves as a single point for
monitoring and controlling the network. You can use a Catalyst 3550-12T-L3 switch, as shown, or a
Catalyst 3508GXL sw itch to cr eat e a Gi gabit ba ckbone . A C ata lyst 3550-12T-L3 backbone switch
provides the benefits of inter-VLAN routing and allows the router to focus on WAN access.
The workgroups are created by clustering all the Catalyst switches except the Catalyst4908G-L3 switch.
Using CMS and Cisco switch clustering technology, you can group the switches into multiple c lust ers,
as shown, or into a single cluster. You can manage a cluster through the IP address of its active and
standby command switches, regardless of the geographic location of the cluster members.
This network uses VLANs to segment the network logically into well-defined broadcast groups and fo r
security management. Data and multimedia traffic are configured on the same VL AN. Voice traffic from
the Cisco IP Phones are configured on separate voice VLAN IDs (VVIDs). You can have up to
four VVIDs per wiring closet. If data, multimedia, and voice traf fic are assign ed to the same VLAN, only
one VLAN can be configured per wiring closet. For any switch port connected to Cisco IP Phones,
802.1p or 802.1Q QoS gives forwarding priority to voice traffic over data traffic.
Grouping servers in a centralized location provides benefits s uch as security an d easier maintena nce. The
Gigabit connections to a server farm provide the workgroups full access to the network resources (such
as a call-processing server running Cisco CallManager software, a DHCP server, or an IP/TV multicast
server).
Cisco IP Phones are connected—using standard straight-through, twisted-pair cable with RJ-45
connectors—to the 10/100inline-power ports on the Catalyst 3550-24PWR switches and to the
10/100 ports on the Catalyst2950 switches. These multiservice switch ports automatically detect any IP
phones that are connected. Cisco CallManager controls call processing, routing, and IP phone features
and configuration. Users with workstations running Cisco SoftPhone software can place, receive, and
control calls from their PCs. Using Cisco IP Phones, Cisco CallManager software, and Cisco SoftPhone
software integrates telephony and IP networks, and the IP network supports both voice and d ata .
Each 10/100inline-power port on the Catalyst 3550-24PWR switches provides –48 VDC power to the
Cisco IP Phone. The IP phone can receive redundant power when it is also connected to an AC power
source. IP phones not connected to the Catalyst 3550-24PWR switches receive power from an AC power
source.