18-13
Catalyst2950 and Catalyst2955 Switch Software Configuration Guide
78-11380-10
Chapter18 Configuring VTP Configuring VTP
Note You can also configure VTP transparent mode by using the vlan database privileged EXEC command
to enter VLAN configuration mode and by entering the vtp transparent command, similar to the second
procedure under the Configuring a VTP Server section on page18-9. Use the no vtp transparent
VLAN configuration command to return the switch to VTP server mode. If extended-range VLANs are
configured on the switch, you cannot change VTP mode to ser ver. Y ou receive an error message, and the
configuration is not allowed.
Enabling VTP Version 2
VTP version 2 is disabled by default on VTP version 2-capable switches. When you enable VTP
version 2 on a switch, every VTP version 2-capable switch in the VTP domain enables version 2. You
can only configure the version on switches in VTP server or transparent mode.
Caution VTP version 1 and VTP version 2 are not interoperable on switches in the same VTP domain. Every
switch in the VTP domain must use the same VTP version. Do not enable VTP version 2 unless every
switch in the VTP domain supports version2.
Note In TrCRF and TrBRF Token ring environments, you must enable VTP version 2 for Token Ring VLAN
switching to function properly. For Token Ring and Token Ring-Net media, VTP version 2 must be
disabled.
For more information on VTP version configuration guidelines, see the VTP Version section on
page 18-9.
Beginning in privileged EXEC mode, follow these steps to enable VTP version 2:
To disable VTP version 2, use the no vtp version global configuration command.
Note You can also enable VTP version 2 by using the vlan database privileged EXEC command to enter
VLAN configuration mode and entering the vtp v2-mode VLAN configuration command. To disable
VTP version 2, use the no vtp v2-mode VLAN configuration command.
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 vtp version 2 Enable VTP version 2 on the switch.
VTP version 2 is disabled by default on VTP version2-capable switches.
Step3 end Return to privileged EXEC mode.
Step4 show vtp status Verify that VTP version 2 is enabled in the VTP V2 Mode field of the display.