Cisco Systems 2950 Using the show controllers Commands

32-22
Catalyst2950 and Catalyst2955 Switch Software Configuration Guide
78-11380-10
Chapter32 Troubleshooting
Using the show controllers Commands
For more information about auto-QoS, see the “Configuring Auto-QoS” section on page 30-9.
This example shows how to display the QoS commands th at are a utomaticall y gene rated wh en aut o-QoS
is enabled:
Switch# debug auto qos
AutoQoS debugging is on
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# auto qos voip cisco-phone
Using the show controllers Commands
You can display the statistics, configuration, and other information about the Catalyst 2950 LR E switch,
the connected CPE devices, and the LRE link. Use the privileged EXEC commands in Ta ble 32- 3 to
display this information:
For more information about the fields in the command output, refer to the switch command reference for
this release.
Step5 end Return to privileged EXEC mode.
Step6 show auto qos interface interface-id Verify your entries.
This command displays the auto-QoS configuration that was initially
applied; it does not display any user changes to the configuration that
might be in effect.
Command Purpose
Table32-3 Commands for Displaying LRE and CPE Information
show controllers ethernet-controller
interface-id [asic | cpe [port port-id] | phy]Displays per-interface transmit and receive statis tics read from th e hardware, the interface internal registers, and the statistics read from LRE and CPE
ports.
show controllers lre cpe {identity | mfg |
protected | version} [interface-id]Displays information about the Cisco LRE CPE devices connected to an LRE switch.
show controllers lre Displays information about the LRE link.
show controllers lre log Displays the history of the link, configuration, and timer events for a specific
LRE interface or for all the LRE switch interfaces.