28-4
Catalyst2950 and Catalyst2955 Switch Software Configuration Guide
78-11380-10
Chapter28 Configuring SNMP
Understanding SNMP
SNMP Agent Functions
The SNMP agent responds to SNMP manager requests as follows:
Get a MIB variableThe SNMP agent begins this function in response to a request from the NMS.
The agent retrieves the value of the requested MIB variable and responds to the NMS with that v alue.
Set a MIB variableThe SNMP agent begins this function in response to a message from the NMS.
The SNMP agent changes the value of the MIB variable to the value requ este d by the N MS.
The SNMP agent also sends unsolicited trap messages to notify an NMS that a significant event has
occurred on the agent. Examples of trap conditions include, but are not limited to, when a port or module
goes up or down, when spanning-tree topology changes occur, and when authentication failures occur.
SNMP Community Strings
SNMP community strings authenticate access to MIB objects and function as embedded passwords. In
order for the NMS to access the switch, the community string definitions on the NMS must match at least
one of the three community string definitions on the switch.
A community string can have one of these attributes:
Read-only (RO)Gives read access to authorized management stations to all objects in the MIB
except the community strings, but does not allow write access
Read-write (RW)Gives read and write access to authorized management stations to all objects in
the MIB, but does not allow access to the community strings
Note When a cluster is created, the command switch manages the exchange of messages among member
switches and the SNMP application. The Cluster Management software appends the member switch
number (@esN, where N is the switch number) to the first configured RW and RO community strings on
the command switch and propagates them to the member sw itches. F or m ore info rmatio n, see Chapter7,
Clustering Switches.
Using SNMP to Access MIB Variables
An example of an NMS is the CiscoWorks network management software. CiscoWorks 2000 software
uses the switch MIB variables to set device variables and to poll devices on the network for specific
information. The results of a poll can be displayed as a gra ph and a naly zed to t roub lesho ot
internetworking problems, increase network performance, verify the configuration of devices, monitor
traffic loads, and more.
As shown in Figure 28-1, the SNMP agent gathers data from the MIB. The agent can send traps, or
notification of certain events, to the SNMP manager, which receives and processes the traps. Traps alert
the SNMP manager to a condition on the network such as improper user authentication, restart s, link
status (up or down), MAC address tracking, and so forth. The SNMP agent also responds to MI B-related
queries sent by the SNMP manager in get-request, get-next-request, and set-request format.