Cisco Systems 2 Upgrading to Cisco Unified Service Monitor, Before You Upgrade to Service Monitor

For more information, see NTP Configuration Notes, page 10.

Step 12 A message appears asking whether to reboot your system now. Reboot your system before you start Step 13.

Step 13 After the installation completes, verify that Service Monitor was installed correctly by starting Service Monitor. See Starting Cisco Unified Service Monitor, page 26.

After You Install Service Monitor

You should exclude the NMSROOT\databases directory from virus scanning. Problems can arise if database files are locked because of virus scanning.

Note NMSROOT is the directory where Service Monitor is installed on your system. If you selected the default directory during installation, it is C:\Program Files\CSCOpx.

6Upgrading to Cisco Unified Service Monitor 2.0

This section includes the following:

•Before You Upgrade to Service Monitor 2.0, page 20

•Performing the Upgrade to Service Monitor 2.0, page 21

•Performing Post-Upgrade Configuration, page 24

Before You Upgrade to Service Monitor 2.0

It is recommended that you delete existing sensor configuration and binary image files from your existing TFTP servers before you perform the upgrade. Delete the following files:

•Sensor configuration files: One QOVDefault.CNF file and a QoVMACAddress.CNF file for each sensor.

•Binary image file: SvcMonAA2_24.img.

You must perform post-upgrade configuration immediately after you upgrade to the Service Monitor

2.0software, or the sensors will be unable to register to Service Monitor; for more information, see Performing Post-Upgrade Configuration, page 24.

If you plan to add Cisco Unified CallManagers to Service Monitor, configure the server to use NTP before you upgrade. For more information, see NTP Configuration Notes, page 10.

20