20-14
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-03
Chapter20 Co nf iguring QoS
Understanding QoS
WRED
Cisco’s implementation of Random Early Detection (RED), called Weighted Random Ear ly D etec tio n
(WRED), differs from other congestion-avoidance techniques because it attempts to anticipate and avoid
congestion, rather than controlling congestion once it occurs.
WRED takes advantage of TCP congestion control to try to control the average q ueue size by indicating
to end hosts when they should temporarily stop sending packets. By rand omly dropping packets before
periods of high congestion, it tells the packet source to decrease its transmission rate. Assuming the
packet source is using TCP, WRED tells it to decrease its transmission rate until all the packets reach
their destination, meaning that the congestion is cleared.
WRED reduces the chances of tail drop by selectively dropping packets when the outp ut interface begins
to show signs of congestion. By dropping some packets early rather than waiting until the queue is full,
WRED avoids dropping large numbers of packets at once. Thus, WRED allows the transmission line to
be fully used at all times. WRED also drops more packets from large users than small. Therefore, traffic
sources that generate the most traffic are more likely to be slowed down than traffic sources that genera te
little traffic.
You can enable WRED and configure the two threshold percentages assigned to the four egress queues
on a Gigabit-capable Ethernet port by using the wrr-queue random-detect max-threshold interface
configuration command. Each threshold percentage represents where WRE D starts to random ly drop
packets. After a threshold is exceeded, WRED randomly begins to drop packets assigned to this
threshold. As the queue limit is approached, WRED continues to drop more and more packets. When the
queue limit is reached, WRED drops all packets assigned to the threshold. By default, WRED is
disabled.
You modify the DSCP-to-threshold map to determine which DSCPs are mapped to which thres hold I D
by using the wrr-queue dscp-map interface configuration command. By defaul t, all DSC Ps are map ped
to threshold 1, and when this threshold is exceeded, all the pa ck ets are ran dom ly d rop ped.
If you use WRED thresholds, you cannot use tail drop, and vice versa. If WRED is disabled, tail drop is
automatically enabled with the previous configuration (or the default if it was not previously
configured).