Cisco Systems 3550 - page 52

2-2
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-03
Chapter2 Us ing the Command-Line Interface
IOS Command Modes
Table2-1 Command Mode Summary
Mode Access Method Prompt Exit Method About This Mode
User EXEC Begin a session with
your switch. Switch> Enter logout or quit. Use this mode to
•Change terminal
settings.
•Perform basic tests.
•Display system
information.
Privileged EXEC While in user EXEC
mode, enter the enable
command.
Switch# Enter disable to exit. Use this mode to verify
commands that you have
entered. Use a password
to protect access to this
mode.
VLAN configuration While in privileged
EXEC mode, enter the
vlan database
command.
Switch(vlan)# To exit to privileged
EXEC mode, enter
exit.
Use this mode to
configure
VLAN-specific
parameters.
Global configuration While in privileged
EXEC mode, enter the
configure command.
Switch(config)# To exit to privileged
EXEC mode, enter
exit or end, or press
Ctrl-Z.
Use this mode to
configure parameters that
apply to the entire switch.
Interface
configuration While in global configuration mode,
enter the interface
command (with a
specific interface).
Switch(config-if)# To exit to global
configuration mode,
enter exit.
To return to
privileged EXEC
mode, press Ctrl-Z or
enter end.
Use this mode to
configure parameters for
the Ethernet interfaces.
To configure multiple
interfaces with the same
parameters, see the
“Configuring a Range of
Interfaces” section on
page 8-9.
Line configuration While in global
configuration mode,
specify a line with the
line vty or line console
command.
Switch(config-line)# To exit to global
configuration mode,
enter exit.
To return to
privileged EXEC
mode, press Ctrl-Z or
enter end.
Use this mode to
configure parameters for
the terminal line.