Cisco Systems 78-11741-02 manual Monitoring and Maintaining PGM Host, IPC-499

Configuring PGM Host and Router Assist

Monitoring and Maintaining PGM Host and Router Assist

Enabling PGM Router Assist with a Virtual Host Interface

To enable PGM Router Assist on a vif, use the following command in interface configuration mode:

Command	Purpose
Router(config-if)# ip pgm router	Enables the router to assist PGM on this interface.
	Note You must configure a vif by using the interface vif number
	global configuration command on the router before enabling
	PGM Assist on the router; otherwise, PGM Assist will not
	be enabled on the router.

See the “PGM Router Assist with a Virtual Interface Example” section later in this chapter for an example of enabling PGM Router Assist with a virtual interface.

Enabling PGM Router Assist with a Physical Interface

To enable PGM Router Assist on the router and to configure the router to forward PGM packets through a physical interface, use the following commands in interface configuration mode:

Command	Purpose
Router(config-if)# ip pgm router	Enables the router to assist PGM on this interface.

See the “PGM Router Assist with a Physical Interface Example” section later in this chapter for an example of enabling PGM Router Assist with a physical interface.

Monitoring and Maintaining PGM Host and Router Assist

This section provides information on monitoring and maintaining the PGM Host and Router Assist feature.

Monitoring and Maintaining PGM Host

Note Support for the PGM Host feature has been removed. Use of this feature is not recommended.

To reset PGM Host connections, use the following command in privileged EXEC mode:

Command	Purpose
Router# clear ip pgm host {defaults traffic}	Resets PGM Host connections to their default values and clears
	traffic statistics.

Cisco IOS IP Configuration Guide

IPC-499