Cisco Systems 78-11741-02 SSM Configuration Task List, Configuring SSM, Monitoring SSM, IPC-467

Configuring Source Specific Multicast

SSM Configuration Task List

compiled with the HSIL will then dynamically bind to the newest version of the HSIL, which should support the check for IGMPv3 in the operating system kernel. Upgrading the HSIL can be done independently of upgrading the application itself.

SSM Configuration Task List

To configure SSM, perform the tasks described in the following sections. The tasks in the first section are required; the tasks in the remaining section are optional.

•Configuring SSM (Required)

•Monitoring SSM (Optional)

Configuring SSM

To configure SSM, use the following commands beginning in global configuration mode:

	Command	Purpose
Step 1
	Router(config)# ip pim ssm [default range	Defines the SSM range of IP multicast addresses.
	access-list]
Step 2
	Router(config)# interface type number	Selects an interface that is connected to hosts on which
		IGMPv3, IGMP v3lite, and URD can be enabled.
Step 3
	Router(config-if)# ip pim {sparse-mode	Enables PIM on an interface. You must use either sparse mode
	sparse-dense-mode}	or sparse-dense mode.
Step 4
	Router(config-if)# ip igmp version 3	Enables IGMPv3 on this interface. The default version of IGMP
		is set to Version 2.
	or	or
	Router(config-if)# ip igmp v3lite	Enables the acceptance and processing of IGMP v3lite
		membership reports on an interface.
	or	or
	Router(config-if)# ip urd	Enables interception of TCP packets sent to the reserved URD
		port 465 on an interface and processing of URD channel
		subscription reports.

Monitoring SSM

To monitor SSM, use the following commands in privileged EXEC mode, as needed:

Command		Purpose
Router#	show ip igmp groups detail	Displays the (S, G) channel subscription through IGMPv3,
		IGMP v3lite, or URD.
Router#	show ip mroute	Displays whether a multicast group supports SSM service or
		whether a source-specific host report was received.

Cisco IOS IP Configuration Guide

IPC-467