Cisco Systems 78-11741-02 IP Multicast Configuration Examples, PIM Dense Mode Example, IPC-448

Configuring IP Multicast Routing

IP Multicast Configuration Examples

IP Multicast Configuration Examples

This section provides the following IP multicast routing configuration examples:

•PIM Dense Mode Example

•PIM Sparse Mode Example

•PIM Dense Mode State Refresh Example

•Functional Address for IP Multicast over Token Ring LAN Example

•PIM Version 2 Examples

•RTP Header Compression Examples

•IP Multicast over ATM Point-to-Multipoint VC Example

•Administratively Scoped Boundary Example

•IP Multicast Helper Example

•Stub IP Multicast Example

•Load Splitting IP Multicast Traffic Across Equal-Cost Paths Example

•IP Multicast Heartbeat Example

PIM Dense Mode Example

The following example configures PIM dense mode on Fast Ethernet interface 0/1 of the router:

ip multicast-routing

interface FastEthernet0/1

ip address 172.16.8.1 255.255.255.0 ip pim dense-mode

PIM Sparse Mode Example

The following example configures the Cisco IOS software to operate in PIM sparse mode. The RP router is the router whose address is 10.8.0.20.

ip multicast-routing

ip pim rp-address 10.8.0.20 1 interface ethernet 1

ip pim sparse-mode

Cisco IOS IP Configuration Guide

IPC-448