If you want to...

Then...

 

 

Stop Found New

1. Click Next to use the wizard dialog box.

Hardware Wizard

2.

In the Update New Software dialog, click No, not this time, and click

from opening when

 

Next.

connecting to USB

 

3.

Click Install the Software automatically (Recommended) and click Next.

port

 

 

 

4.

After a few moments, the Cannot Install This Hardware dialog appears.

 

 

Click Don't prompt me again to install this software.

 

5.

Click Finish to close the dialog box.

 

 

 

Powering On the Phone

After charging the battery, you must power on the phone to make and receive calls.

If you want to...

Then...

Power on the phone 1. Press and hold the (red button) until the phone powers on.

2.You might need to enter a username and password to access the wireless network. For more information, see Setting Username and Passwords, page 15.

3.After completing authentication and registration with Cisco Unified Communications Manager, the phone displays the main screen and is ready to place or receive calls.

Check signal strength The

icon indicates the strength of the signal between the wireless access

point and your phone. Your phone must have at least one bar to place or

receive calls.

When you move the phone out of signal range, you lose connection with the wireless LAN. The icon appears, and the status line displays, “Leaving service area.”

Tip

Your idle phone screen can turn off after a time interval. To alert you that the phone is still powered on and connected to the wireless network when using battery power, the indicator light blinks green every two seconds.

14

OL-16132-01

Page 22
Image 22
Cisco Systems 7925G Powering On the Phone, Next, Click Dont prompt me again to install this software, If you want to, Tip