Cisco Systems 7925G manual Using Conference, Using Join, Participants, EndCall, or Options EndCall

•cBarge—Allows you to create a standard (ad hoc) conference by adding yourself to a call on a shared line. Use the cBarge softkey. cBarge is available only on phones that use shared lines.

•Meet-Me—Allows you to create or join a conference by calling a conference number. Use the MeetMe softkey.

Using Conference

Conference allows you to call each participant. Conference is available on most phones.

If you want to...	...Then
Create a conference	1.	From a connected call, choose Options > Confrn.
	2.	Enter the participant’s phone number.
	3.	Wait for the call to connect.
	4.	Choose Options > Confrn again to add the participant to your
		call.
	5.	Repeat to add additional participants.
Add new participants to an	Repeat the steps listed above.
existing conference	Your system administrator determines whether non-initiators of a
	conference can add or remove participants.
See a list of conference	Choose Options > ConfList. See Viewing or Removing Conference
participants or remove	Participants, page 49.
participants
End your participation in a	Choose		, EndCall, or Options > EndCall.
conference

Tips

•Calls must be on the same line before you can add them to a conference. If calls are on different lines, transfer them to a single line before using Confrn or Join.

•Depending on how your phone is configured, if you leave a conference after initiating it, the conference might end. To avoid this, transfer the conference before hanging up.

Using Join

Join allows you to combine two or more existing calls to create a conference in which you are a participant.

46 OL-16132-01