Cisco Systems ATA 186 manual ReorderTone Parameter Example, 5-35, Component, Setting, Explanation

Chapter 5 Parameters and Defaults

Tone Configuration Parameters

Table 5-5 Reorder Tone Parameter Example 1 Explanation (continued)

Component	Setting	Explanation
NumOfRepeats	0	First on-off pair of the cadence plays once
		(does not repeat), then the second on-off pair
		plays
TotalToneTime	0	Tone plays continuously (set of three on-off
		pairs of the cadence repeat continuously) until
		another call event stops the tone

ReorderTone Parameter Example 2

Assume that you want a reorder tone in which:

•The only frequency is 400 Hz.

•The frequency plays six times, each time for 0.1 second followed by 0.9 second of silence.

•The frequency then plays once for 0.3 second followed by 0.7 second of silence.

•The volume of the frequency is –19 dBm.

•The tone plays until another call event stops the tone.

For this reorder tone, make the following setting. See Table 5-6for a detailed explanation.

ReorderTone:100,1,31164,1620,0,0,0,0,2,800,7200,2400,5600, 0,0,5,0

Table 5-6 Reorder Tone Parameter Example 2 Explanation

Component	Setting	Explanation
Sequential	100	Required setting for a tone with one frequency
NumOfFreqs	1	One frequency in the tone
TFreq1	31164	First frequency is 400 Hz
TAmp1	1620	First frequency volume is –19 dBm
TFreq2	0	No second frequency
TAmp2	0	No second frequency
TFreq3	0	No third frequency
TAmp3	0	No third frequency
NumOfOnOffPairs	2	Two on-off pairs in the cadence of the tone
OnTime1	800	Sound in first on-off pair plays for 0.1 second
OffTime1	7200	Sound in first on-off pair is followed by 0.9
		second of silence
OnTime2	2400	Sound in second on-off pair plays for 0.3
		seconds
OffTime2	5600	Sound in second on-off pair is followed by 0.7
		second of silence
OnTime3	0	No third on-off pair in the cadence
OffTime3	0	No third on-off pair in the cadence

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)

OL-4803-01 5-35