Cisco Systems CP7945G manual Ending a Call, Using Hold and Resume, Or EndCall

Ending a Call

To end a call, simply hang up. Here are some more details.

If you want to...	Then...
Hang up while using the handset	Return the handset to its cradle. Or press EndCall.
Hang up while using a headset	Press	. Or, to keep headset mode active, press EndCall.
	Cisco Unified IP Phone 7975G, 7965G, and 7945G support
	a wireless headset. If you are using a wireless headset, refer
	to the wireless headset documentation for instructions.
Hang up while using the speakerphone	Press	or EndCall.
Hang up one call, but preserve another	Press EndCall. If necessary, remove the call from hold first.
call on the same line

Using Hold and Resume

You can hold and resume calls. When you put a call on hold, the Hold icon appears on the right in the call information area and the corresponding line button flashes green . With a shared line, the line button flashes green when you place a call on hold, and the phone displays the hold icon. When another phone places a call on hold, the line button flashes red, and the phone displays the remote hold icon.

If the Hold Reversion feature is enabled for your phone, a call that you put on hold reverts to ringing after a certain time. The “reverting” call remains on hold until you resume it or until Hold Reversion times out. Your phone indicates the presence of a reverting call by the following:

•Alerting you at intervals with a single ring (or flash or beep, depending on your phone line setting).

•Briefly displaying a “Hold Reversion” message in the status bar at the bottom of the phone screen.

•Displaying the animated Hold Reversion icon next to the caller ID for the held call.

•Displaying a flashing amber line button (depending on the line state).

If you want to...	...Then
Put a call on hold	1.	Make sure the appropriate call is highlighted.
	2.	Press Hold.
Remove a call from	1.	Make sure the appropriate call is highlighted.
hold on the current line	2.	Press Resume.

26 OL-22332-01