Power
CAUTION: This unit is intended for indoor use only. Do not install near water or expose this unit to moisture. To prevent heat buildup, do not coil the power cord when in use. Do not use extension cords. Do not attempt to make any internal changes to the power source. Do not attempt to modify any portion or component of a
CAUTION:
CAUTION: Before removing or replacing any modules, turn off main power switch located on the DS- Series Base Unit. Communication to the
QUICK START: DS71-MD4 Module
by Bay Technical Associates
For those Administrators who have requested the bare minimum for this type of equipment, follow these steps exactly. If this is a new unit shipped directly from Baytech, follow the steps. If this is a previously own unit, perform a factory reset to clear out any users and passwords still in the unit.
Serial/Modem Configuration:
1.Connect the
2.Connect the supplied rollover flat cable RJ08X007 to the adapter and to the EIA232 serial port on the Baytech
3.Use terminal emulation software to access the unit, (i.e. Microsoft
4.If you get only a blinking cursor Press ‘Enter’. If still only a blinking cursor, Type 5
5.Select ‘C’ for the configuration menu.
6.Select the
7.Select the number for ‘Login Setup’ option. You should see a menu similar to (Figure 3).
8.Select the number for ‘Manage Users’ option. You should see a menu similar to (Figure 4).
9.NOTE: The ‘admin’ user can not be deleted.
10.Select ‘A’ to add user. Type the name and password at the prompts.
11.Press ‘Enter’ until get to the ‘Login Setup Menu’ (Figure 3).
12.Select option ‘Access Control’ to enable or disable the Modem and Serial Login Prompts.
13.Press ‘Enter’ until get to the ‘Login Setup Menu’ (Figure 3).
14.Select option ‘Assign User Ports’ (Figure 5).
15.Select the user and add the ports.
16.Press ‘Enter’ until you get the Configuration menu (Figure 2).
17.Select ‘Serial Port Configuration’ and set up the modem configuration.
At this point you have setup enough basic configurations to operate this Baytech unit.
Serial Setup
•Connect the
6