Cisco Systems DSC9148D8G48PK9 manual Enabling Port Group Monitor

Chapter 2 Configuring Interfaces

Configuring Interfaces

•Reverting to the Default Policy for a Specific Counter, page 2-36

•Turning Off the Monitoring of Specific Counter, page 2-36

•Activating a Port Group Monitor Policy, page 2-37

Enabling Port Group Monitor

Detailed Steps

	To enable port group monitor, follow these steps:
	Command	Purpose
Step 1
	switch# config t	Enters configuration mode.
Step 2
	switch(config)# port-group-monitor enable	Enables (default) port group monitoring.
	switch(config)# no port-group-monitor enable	Disables port group monitoring.

Configuring a Port Group Monitor Policy

Detailed Steps

To configure port group monitor policy, follow these steps:

	Command	Purpose
Step 1
	switch# config t	Enters configuration mode.
Step 2
	switch(config)# port-group-monitor name	Specifies the policy name and enters the port
	policyname	group monitoring policy configuration mode.
	switch(config)# no port-group-monitor name	Removes the policy.
	policyname
Step 3
	switch(config-port-group-monitor)# counter	Specifies the delta Rx counter poll interval in
	rx-performance poll-interval seconds delta	seconds and thresholds in percentage.
	rising-threshold percentage1
	falling-threshold percentage2
	switch(config-port-group-monitor)# counter	Specifies the delta Tx counter poll interval in
	tx-performance poll-interval seconds delta	seconds and thresholds in percentage.
	rising-threshold percentage1
	falling-threshold percentage2
	switch(config-port-group-monitor)# no	1Reverts to the 2default policy.
	counter tx-performance
Step 4
	switch(config-port-group-monitor)# monitor	Turns on Rx performance monitoring.
	counter rx-performance
	switch(config-port-group-monitor)# monitor	Turns on Tx performance monitoring.
	counter tx-performance
	switch(config-port-group-monitor)# no	3Turns off Tx performance monitoring.
	monitor counter tx-performance

1.See Reverting to the Default Policy for a Specific Counter, page 2-36.

2.See Port Group Monitor, page 2-16

3.See Turning Off the Monitoring of Specific Counter, page 2-36.

	Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
OL-29284-01, Release 6.x		2-35