Cisco Systems DSC9148D8G48PK9 manual Deleting PortChannels, Adding an Interface to a PortChannel

Chapter 6 Configuring PortChannels

Configuring PortChannels

	Command	Purpose
Step 3 switch(config-if)# channel mode active		Configures the ACTIVE mode.
	switch(config-if)#no channel mode active	Reverts to the default ON mode.

Deleting PortChannels

Detailed Steps

	To delete a PortChannel, follow these steps:
	Command	Purpose
Step 1
	switch# config t	Enters configuration mode.
	switch(config)#
Step 2
	switch(config)# no interface port-channel 1	Deletes the specified PortChannel (1), its
	port-channel 1 deleted and all its members	associated interface mappings, and the
	disabled	hardware associations for this PortChannel.
	please do the same operation on the switch at the
	other end of the port-channel
	switch(config)#

Adding an Interface to a PortChannel

Detailed Steps

To add an interface to a PortChannel, follow these steps:

	Command	Purpose
Step 1
	switch# config t	Enters configuration mode.
	switch(config)#
Step 2
	switch(config)# interface fc1/15	Configures the specified port interface (fc1/15).
	switch(config-if)#
Step 3
	switch(config-if)# channel-group 15	Adds physical Fibre Channel port 1/15 to
		channel group 15. If channel group 15 does not
		exist, it is created. The port is shut down.

To add a range of ports to a PortChannel, follow these steps:

	Command	Purpose
Step 1
	switch# config t	Enters configuration mode.
	switch(config)#

	Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
6-18	OL-29284-01, Release 6.x