Cisco Systems DSC9148D8G48PK9 manual Verifying Fibre Channel Interfaces Configuration

Chapter 3 Configuring Fibre Channel Interfaces

Verifying Fibre Channel Interfaces Configuration

Detailed Steps

To release the shared resources for a port group, follow these steps:

	Command	Purpose
Step 1
	switch# config t	Enters configuration mode.
	switch(config)#
Step 2
	switch(config)# interface fc 1/1	Selects the interface and enters interface
	switch(config-if)#	configuration submode.
		Tip	You can use an interface range to
			release the resources for all interfaces
			in a port group.
Step 3
	switch(config-if)# no channel-group	Removes the interface from a PortChannel.
Step 4
	switch(config-if)# shutdown	Disables the interface.
Step 5
	switch(config-if)# out-of-service	Takes the interface out of service.
	Putting an interface into out-of-service will
	cause its shared resource configuration to
	revert to default
	Do you wish to continue(y/n)? [n] y
Step 6
	switch(config-if)# no out-of-service	Makes the interface available for service.
		Repeat Step 2 through Step 6 for all the
		interfaces in the port group.

Disabling ACL Adjacency Sharing for System Image Downgrade

Fibre Channel ACL adjacency sharing is enabled by default on the switches with an active Generation 2 switching module as of Cisco MDS SAN-OS Release 3.0(3), and with an active Generation 3 module as of MDS NX-OS Release 4.1(1). Fibre Channel ACL adjacency sharing improves the performance for zoning and inter-VSAN routing (IVR) network address translation (NAT). To prevent disruptions when downgrading the system image on your switch to a release prior to Cisco SAN-OS Release 3.0(3), enter the following command in EXEC mode:

switch# system no acl-adjacency-sharing

To reenable Fibre Channel ACL adjacency sharing on your switch, enter the following command in EXEC mode:

switch# system acl-adjacency-sharing

Verifying Fibre Channel Interfaces Configuration

To display Fibre Channel interface configuration information, perform one of the following tasks:

	Command		Purpose
	show module		Displays the module.
	show module slot recovery-steps		Displays the slot for the module.
	show port-resources module slot		Displays the port resources for the slot.
		Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
OL-29284-01, Release 6.x				3-43