Cisco Systems DSC9148D8G48PK9 manual Verifying Trunking Configuration

Chapter 5 Configuring Trunking

Verifying Trunking Configuration

	Command	Purpose
Step 3
	switch(config-if)#switchport trunk allowed vsan 2-4	Changes the allowed list for the
		specified VSANs.
	switch(config-if)#switchport trunk allowed vsan add 5	Expands the specified VSAN (5) to
	updated trunking membership	the new allowed list.
	switch(config-if)#no switchport trunk allowed vsan 2-4	Deletes VSANs 2, 3, and 4.
	switch(config-if)#no switchport trunk allowed vsan add 5	Deletes the expanded allowed list.

Verifying Trunking Configuration

To display trunking configuration information, perform one of the following tasks:

Command	Purpose
show interface fc slot/port	Displays the interface configuration information
	that includes trunking, trunk mode, allowed
	VSANs, and status.
show trunk protocol	Displays whether the trunk protocol is enabled.
show interface trunk vsan numbers	Displays whether the interface is trunking, and the
	allowed VSAN list for each trunking interface.

For detailed information about the fields in the output from these commands, refer to the Cisco MDS NX-OS Command Reference.

The show interface command is invoked from the EXEC mode and displays trunking configurations for a TE port. Without any arguments, this command displays the information for all of the configured interfaces in the switch. See Examples 5-1to 5-3.

Example 5-1 Displays a Trunked Fibre Channel Interface

switch# show interface fc1/13 fc1/13 is trunking

Hardware is Fibre Channel

Port WWN is 20:0d:00:05:30:00:58:1e

Peer port WWN is 20:0d:00:05:30:00:59:1e Admin port mode is auto, trunk mode is on

Port mode is TE
Port vsan is 1
Speed is 2 Gbps
Receive B2B	Credit is 255
Beacon is turned off
Trunk vsans	(admin allowed and active) (1)
Trunk vsans	(up)	(1)
Trunk vsans	(isolated)	()
Trunk vsans	(initializing)	()

5		minutes input		rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5		minutes output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
		233996 frames		input, 14154208	bytes,	0 discards
		0	CRC, 0 unknown class
		0	too long,	0 too short
		236	frames output, 13818044 bytes, 0			discards
		11 input OLS,		12 LRR, 10 NOS,	28 loop inits
					Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
	OL-29284-01, Release 6.x						5-13