Cisco Systems IE 3000 warranty Equipment That You Supply, Before You Begin

Cisco IE 3000 Switch Getting Started Guide

•Attaching the Power and Relay Connector, page 20

•Optional Procedures, page 21

Equipment That You Supply

Obtain these necessary tools and equipment:

•Ratcheting torque flathead screwdriver that exerts up to 15-inch pound (in-lb) of pressure

•Ring terminal lug (such as Thomas & Bett part number 10RC6 or equivalent)

•Crimping tool (such as Thomas & Bett part number WT2000, ERG-2001, or equivalent)

•10- to 12-gauge copper ground wire (such as Belden part number 9912 or equivalent)

•For DC power connections, use UL- and CSA-rated style 1007 or 1569 twisted-pair copper appliance wiring material (AWM) wire (such as Belden part number 9318)

•Wire-stripping tools for stripping 10-, 12-, and 18-gauge wires

•For rack-mounting, a number-2 Phillips screwdriver

•A flat-blade screwdriver

Before You Begin

When you determine where to install the switch, verify that these guidelines are met:

•Operating environment is within the range in the switch hardware installation guide.

•Clearance to front and rear panels meets these conditions:

–Front-panel LEDs can be easily read.

–Access to ports is sufficient for unrestricted cabling.

–Front-panel direct current (DC) power and relay connector is within reach of the connection to the DC power source.

	Cisco IE 3000 Switch Getting Started Guide
12	OL-16234-01