
Cisco IE 3000 Switch Getting Started Guide
Step 4 Position the rear panel of the switch directly in front of the DIN rail, making sure that the DIN rail fits in the space between the two latches.
DIN rail
202339
Step 5 Push the DIN rail latches in after the switch is over the DIN rail to secure the switch to the rail. You hear a click when the latches are completely locked.
Step 6 Connect power to the switch.
See the wiring instructions in the “Grounding the Switch” section on page 17 and the “Wiring the DC Power Source” section on page 18.
Grounding the Switch
Follow these steps to connect the switch to a protective ground.
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Step 1 Use a standard Phillips screwdriver or a ratcheting torque screwdriver with a Phillips head to remove the ground screw from the front panel of the switch. Store the ground screw for later use.
Step 2 Use a wire stripping tool to strip the 10- to
± 0.02 inch (0.5 mm).
0.5 inch (12.7 mm) 

119516
|
| Cisco IE 3000 Switch Getting Started Guide |
|
|
|
|
| ||
|
|
| 17 | |
|
|
|