![](/images/new-backgrounds/1109054/109054123x1.webp)
Chapter 2 Switch Installation
Connecting Destination Ports
Connecting Destination Ports
These section provide more information about connecting to the destination ports:
•Connecting to 10/100 and 10/100/1000 Ports, page
•Installing and Removing SFP Modules, page
•Connecting to SFP Modules, page
•Connecting to a
•Connecting to
Connecting to 10/100 and 10/100/1000 Ports
The switch 10/100/1000 ports automatically configure themselves to operate at the speed of attached devices. If the attached ports do not support autonegotiation, you can explicitly set the speed and duplex parameters. Connecting devices that do not autonegotiate or that have their speed and duplex parameters manually set can reduce performance or result in no linkage.
To maximize performance, choose one of these methods for configuring the Ethernet ports:
•Let the ports autonegotiate both speed and duplex.
•Set the port speed and duplex parameters on both ends of the connection. Follow these steps to connect to
Caution To prevent
Step 1 When connecting to workstations, servers, routers, and Cisco IP Phones, connect a
When connecting to
The
| Cisco IE 3000 Switch Hardware Installation Guide |
|