D-4
Cisco IE 3000 Switch Hardware Installation Guide
OL-13017-01
Appendix D Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
interface FastEthernet1/1
!
interface FastEthernet1/2
!
interface FastEthernet1/3
!
...(output abbreviated)
!
interface GigabitEthernet1/1
!
interface GigabitEthernet1/2
!
end
Step 10 These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it
in NVRAM by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
After you complete the setup program, the switch can run the default configuration that you created. If
you want to change this configuration or want to perform other manageme nt tasks, use one of these tools:
• Command-line interface (CLI)
• Cisco Network Assistant (for one or more switches)
To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal
emulation program or through the network by using Telnet. For configuration information, see the switch
software configuration guide or the switch command reference.
To use the Cisco Network Assistant, see the Getting Started with Cisco Network Assistant guide on
Cisco.com.