Cisco Systems IE 3000 Series, IEM30004PC manual Connecting the Switch to the Power Converter

Appendix B Installation In a Hazardous Environment

Connecting the Switch to the Power Converter

If an LED is off, the target device might not be turned on, there might be a cable problem, or there might be a problem with the adapter installed in the target device. See Chapter 3, “Troubleshooting,” for solutions to cabling problems.

Step 5 If necessary, reconfigure and restart the switch or target device.

Connecting the Switch to the Power Converter

The Cisco IE 3000 switch can be used with an optional AC/DC power converter (PWR-IE3000-AC). These sections describe the steps required to connect the switch to a power converter:

•Attaching the Power Converter to the Switch, page B-49

•Installing the Power Converter on a DIN Rail, Wall, or Rack Adapter, page B-52

•Connecting the DC Power Clip, page B-52

•Connecting the Power Converter to an AC Power Source, page B-53

•Connecting the Power Converter to a DC Power Source, page B-57

•Applying Power to the Power Converter, page B-59

Attaching the Power Converter to the Switch

Follow these directions to connect the power converter to the switch:

Warning Explosion Hazard—Do not connect or disconnect wiring while the field-side power is on; an electrical arc can occur. This could cause an explosion in hazardous location installations. Be sure that power is removed or that the area is nonhazardous before proceeding. Statement 1081

	Cisco IE 3000 Switch Hardware Installation Guide
OL-13017-01		B-49