Cisco Systems OL-23421-02 manual Tighten the screws

Chapter 2 Installation

Installation

Step 4 Grasp the handles and carefully slide the module into the card guide, then push with both hands until the module is flush against the router chassis (see Figure 2-3).

Figure 2-3 Installing the Switch Module in the CGR 2010 Router

237927

Step 5 Tighten the screws:

a. Tighten the lower flathead screw to the bottom center hole. b. Tighten the second panhead screw to the top center hole.

Step 6 Tighten the three captive screws on the front of the switch module:

a.Tighten the captive screw on the lower left of the module.

b.Tighten the single captive screw on the right side of the module.

c.Finally, tighten the captive screw on the upper left of the module.

The switch module is now successfully installed in the router (see Figure 2-4).

Cisco Connected Grid Ethernet Switch Module Interface Card Getting Started Guide

2-4 OL-23421-02