5-11
Catalyst 3750 SwitchSoftware Configuration Guide
OL-8550-09
Chapter5 Managing Switch Stacks
Understanding Stacks
the mismatched software and tries to upgrade (or downgrade) the switch in version-mismatch mode with
the stack image or with a tar file image from the stack flash memory. The software uses the automatic
upgrade (auto-upgrade) and the automatic advise (auto-advise) features.
The port LEDs on switches in version-mismatch mode will also stay off. Pressing the Mode button does
not change the LED mode.
Note Auto-advise and auto-copy identify which images are running by examining the info file and by
searching the directory structure on the switch stack. If you download your image by using the copy tftp:
command instead of by using the archive download-sw privileged EXEC command, the correct
directory structure is not properly created. For more information about the info file, see the “tar File
Format of Images on a Server or Cisco.com” section on page C-26.
Understanding Auto-Upgrade and Auto-Advise
When the software detects mismatched software and tries to upgrade the switch in version-mismatch
mode, two software processes are involved: automatic upgrade and automatic advise.
•The automatic upgrade (auto-upgrade) process includes an auto-copy process and an auto-extract
process. By default, auto-upgrade is enabled (the boot auto-copy-sw global configuration command
is enabled). You can disable auto-upgrade by using the no boot auto-copy-sw global configuration
command on the master. You can check the status of auto-upgrade by using the show boot privileged
EXEC command and by checking the Auto upgrade line in the display.
–
Auto-copy automatically copies the software image running on any member to the switch in
version-mismatch mode to upgrade (auto-upgrade) it. Auto-copy occurs if auto-upgrade is
enabled, if there is enough flash memory in the switch in version-mismatch mode, and if the
software image running on the stack is suitable for the switch in version-mismatch mode.
Note A switch in version-mismatch mode might not run all released software. For example, new
switch hardware is not recognized in earlier versions of software.
–
Automatic extraction (auto-extract) occurs when the auto-upgrade process cannot find the
appropriate software in the stack to copy to the switch in version-mismatch mode. In that case,
the auto-extract process searches all switches in the stack, whether they are in version-mismatch
mode or not, for the tar file needed to upgrade the switch stack or the switch in
version-mismatch mode. The tar file can be in any flash file system in the stack (including the
switch in version-mismatch mode). If a tar file suitable for the switch in version-mismatch mode
is found, the process extracts the file and automatically upgrades that switch.
The auto-upgrade (auto-copy and auto-extract) processes start a few minutes after the mismatched
software is detected.
When the auto-upgrade process is complete, the switch that was in version-mismatch mode reloads
and joins the stack as a fully functioning member. If you have both StackWise cables connected
during the reload, network downtime does not occur because the stack operates on two rings.
Note Auto-upgrade does not upgrade switches that are loaded with images of different packaging
levels. For example, you cannot use auto-upgrade to upgrade a switch running an IP base image
to an IP services image. However, auto-upgrade does support upgrades between cryptographic
and non-cryptographic images of the same packaging level.