Cisco Systems OL-8550-09 - page 750

31-6
Catalyst 3750 SwitchSoftware Configuration Guide
OL-8550-09
Chapter31 Configuring System Message Logging
Configuring System Message Logging
The logging buffered global configuration command copies logging messages to an internal buffer. The
buffer is circular, so newer messages overwrite older messages after the buffer is full. To display the
messages that are logged in the buffer, use the show logging privileged EXEC command. The first
message displayed is the oldest message in the buffer. To clear the contents of the buffer, use the clear
logging privileged EXEC command.
Use the logging event power-inline-status interface configuration command to enable and to disable
logging of Power over Ethernet (PoE) events on specific PoE-capable ports. Logging on these ports is
enabled by default.
To disable logging to the console, use the no logging console global configuration command. To disable
logging to a file, use the no logging file [severity-level-number | type] global configuration command.
Step3 logging host Log messages to a UNIX syslog server host.
For host, specify the name or IP address of the host to be used as the
syslog server.
To build a list of syslog servers that receive logging messages, enter this
command more than once.
For complete syslog server configuration steps, see the “Configuring
UNIX Syslog Servers” section on page31-12.
Step4 logging file flash:filename
[max-file-size [min-file-size]]
[severity-level-number | type]
Store log messages in a file in flash memory on a standalone switch or, in
the case of a switch stack, on the stack master.
•For filename, enter the log message filename.
•(Optional) For max-file-size, specify the maximum logging file size.
The range is 4096 to 2147483647. The default is 4096 bytes.
•(Optional) For min-file-size, specify the minimum logging file size.
The range is 1024 to 2147483647. The default is 2048 bytes.
•(Optional) For severity-level-number | type, specify either the logging
severity level or the logging type. The severity range is 0 to 7. For a
list of logging type keywords, see Table31-3 on page 31-10. By
default, the log file receives debugging messages and numerically
lower levels.
Step5 end Return to privileged EXEC mode.
Step6 terminal monitor Log messages to a nonconsole terminal during the current session.
Terminal parameter-setting commands are set locally and do not remain
in effect after the session has ended. You must perform this step for each
session to see the debugging messages.
Step7 show running-config Verify your entries.
Step8 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose