35-34
Catalyst 3750 SwitchSoftware Configuration Guide
OL-8550-09
Chapter35 Configuring QoS
Displaying Auto-QoS Information

Troubleshooting Auto QoS Commands

To display the QoS commands that are automatically generated when auto-QoS is enabled or disabled,
enter the debug auto qos privileged EXEC command before you enable auto-QoS. For more
information, see the debug autoqos command in the command reference for this release.
To disable auto-QoS on a port, use the no form of the auto qos command interface configuration
command, such as no auto qos voip. Only the auto-QoS-generated interface configuration commands
for this port are removed. If this is the last port on which auto-QoS is enabled and you enter the no auto
qos voip command, auto-QoS is considered disabled even though the auto-QoS-generated global
configuration commands remain (to avoid disrupting traffic on other ports affected by the global
configuration).
You can use the no mls qos global configuration command to disable the auto-QoS-generated global
configuration commands. With QoS disabled, there is no concept of trusted or untrusted ports because
the packets are not modified (the CoS, DSCP, and IP precedence values in the packet are not changed).
Traffic is switched in pass-through mode (packets are switched without any rewrites and classified as
best effort without any policing).
Displaying Auto-QoS Information
To display the initial auto-QoS configuration, use the show auto qos [interface [interface-id]]
privileged EXEC command. To display any user changes to that configuration, use the show
running-config privileged EXEC command. You can compare the show auto qos and the show
running-config command output to identify the user-defined QoS settings.
To display information about the QoS configuration that might be affected by auto-QoS, use one of these
commands:
•show mls qos
•show mls qos maps cos-dscp
•show mls qos interface [interface-id] [buffers | queueing]
•show mls qos maps [cos-dscp | cos-input-q | cos-output-q | dscp-cos | dscp-input-q |
dscp-output-q]
•show mls qos input-queue
•show running-config
Step7 end Return to privileged EXEC mode.
Step8 show auto qos interface interface-id Verify your entries.
This command displays the auto-QoS command on the interface on
which auto-QoS was enabled. You can use the show running-config
privileged EXEC command to display the auto-QoS configuration
and the user modifications.
Command Purpose