Configuring the HSSI Interfaces

Note For complete command descriptions and examples for the Cisco 7200 series routers and Cisco uBR7200 series routers, refer to the documentation resources listed in the “If You Need More Information” section on page vii.

Proceed to the “Using the ping Command” section on page 7-17 to verify that each interface port is functioning properly.

VIP2 show Commands

Following is an example of how the show interfaces [type slot/port-adapter/port] command displays status information (including the physical slot and port address) for the interfaces you specify. In this example, the VIP2 is in interface processor slot 1, and the PA-2H HSSI port adapter is in port adapter slot 0. (Interfaces are administratively shut down until you enable them.)

Router# show interfaces h 1/0/0 Hssi1/0/0 is up, line protocol is up Hardware is HSSI-B

Internet address is 5.8.1.1/24

MTU 4470 bytes, BW 45045 Kbit, DLY 200 usec, rely 255/255, load 1/255 Encapsulation HDLC, loopback not set, keepalive not set

Last input 2d22h, output 00:00:19, output hang never Last clearing of “show interface” counters 2d20h Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 parity

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 4084 packets output, 1298712 bytes, 0 underruns

0 output errors, 0 applique, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions

Use the show version command to display the configuration of the system hardware (the number of each interface processor type installed), the software version, the names and sources of configuration files, and the boot images.

Following is an example of the show version command used with a Cisco 7000 series system with an RSP7000 processor:

Router# show version

Cisco Internetwork Operating System Software

IOS (tm) GS Software (RSP-JV-MZ), Version 11.1(12)CA1

Copyright (c) 1986-1995 by cisco Systems, Inc.

Compiled Fri 06-Oct-95 12:22 by mpo

Image text-base: 0x600088A0, data-base: 0x605A4000

ROM: System Bootstrap, Version 5.3(5)

ROM: GS Bootstrap Software (RSP-BOOT-M), Version 11.1(12), RELEASED SOFTWARE

Router uptime is 4 hours, 22 minutes

System restarted by reload

System image file is “slot0:rsp-jv-mz”, booted via slot0

cisco RSP7000 (R4600) processor with 16384K bytes of memory. R4600 processor, Implementation 32, Revision 2.0

Last reset from power-on G.703/E1 software, Version 1.0.

7-12PA-2H Dual-Port HSSI Port Adapter Installation and Configuration

Page 56
Image 56
Cisco Systems PA-2H manual VIP2 show Commands