Cisco Systems PA-2H manual Installing a Port Adapter, Installing a New Port Adapter

Installation Overview

Figure 3-4 Pulling a Port Adapter Out of a Slot (Partial Port Adapter View)

H3149

Step 7 If you removed a port adapter, place it in an antistatic container for safe storage or shipment back to the factory. If you removed a blank port adapter, no special handling is required; however, store the blank port adapter for potential future use.

This completes the procedure for removing a port adapter from a VIP2.

Installing a Port Adapter

Following is the standard procedure for installing a port adapter on a VIP2:

Step 1 Remove the new port adapter from its antistatic container and position it at the opening of the slot. (See Figure 3-5.)

Step 2 Carefully align the port adapter carrier between the upper and lower edges of the port adapter slot, as shown in Figure 3-5.

Figure 3-5 Installing a New Port Adapter

H3150

Carrier

Upper edge

Lower edge

3-4PA-2H Dual-Port HSSI Port Adapter Installation and Configuration