Cisco Systems PA-2H manual Removing a Port Adapter

Removing a Port Adapter

When only one port adapter is installed on a VIP2, a blank port adapter must fill the empty slot to allow the VIP2 and router chassis to conform to electromagnetic interference (EMI) emissions requirements, and so that air flows through the chassis properly. If you plan to install a new port adapter, you must first remove the blank port adapter.

Removing a Port Adapter

Following is the standard procedure for removing a port adapter from a VIP2:

Step 1 Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.

Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself.

Note If you want to install a new port adapter on a VIP2 with a single port adapter, you must first remove the blank port adapter from the port adapter slot in which you want to install the new port adapter.

Step 2 For a new port adapter installation or a port adapter replacement, disconnect any interface cables from the ports on the front of the port adapter (although this is not required). You can remove VIP2s with cables attached; however, we do not recommend it.

Step 3 Remove the VIP2 from the system. To do so, follow the steps in the section “Removing a VIP2” in the configuration note Second-Generation Versatile Interface Processor (VIP2) Installation and Configuration , which shipped with your VIP2. Place the removed VIP2 on an antistatic mat.

Step 4 Locate the screw at the rear of the port adapter (or blank port adapter) to be replaced. (See Figure 3-3.) This screw secures the port adapter (or blank port adapter) to its slot.

Figure 3-3 Location of Port Adapter Screw (Partial Port Adapter View)

H3148

Screw

Step 5 Remove the screw that secures the port adapter (or blank port adapter).

Step 6 With the screw removed, grasp the handle on the front of the port adapter (or blank port adapter) and carefully pull it out of its slot, away from the edge connector at the rear of the slot. (See Figure 3-4.)

VIP2 and the Dual-Port HSSI Port Adapter 3-3