Checking the Configuration
Router# show interfaces h 0/0 Hssi0/0 is up, line protocol is up Hardware is
Internet address is 5.8.1.1/24
MTU 4470 bytes, BW 45045 Kbit, DLY 200 usec, rely 255/255, load 1/255 Encapsulation HDLC, loopback not set, keepalive not set
Last input 2d22h, output 00:00:19, output hang never Last clearing of “show interface” counters 2d20h Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 4084 packets output, 1298712 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Use the show version command to display the configuration of the system hardware (the number of each interface processor type installed), the software version, the names and sources of configuration files, and the boot images.
Following is an example of the show version command :
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) GS Software
Copyright (c)
Compiled Fri
Image
ROM: System Bootstrap, Version 5.3(5)
ROM: GS Bootstrap Software
Router uptime is 4 hours, 22 minutes
System restarted by reload
System image file is
cisco RSP2 (R4700) processor with 16384K bytes of memory. R4600 processor, Implementation 32, Revision 2.0
Last reset from
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant. Chassis Interface.
1 VIP2 controllers (2 HSSI).
2 HSSI network interfaces.
125K bytes of
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K). 8192K bytes of Flash internal SIMM (Sector size 256K). Configuration register is 0x2
Cable Installation and Interface Configuration
